COORDINATE SYSTEM

In geometry, a coordinate system is a system which uses one or more numbers, or coordinates, to uniquely determine the position of a point or other geometric element on a manifold such as Euclidean space.

Coordinating-System

ANGLE

A degree (in full, a degree of arc, arc degree, or arc degree), usually denoted by ° (the degree symbol), is a measurement of plane angle, representing 1⁄360 of a full rotation.

Coordinating-System

LINE

Draw menu: LINE Tools

Bar Draw Line

Command entry: L (enter)

Line

LINE Specify first point: (mouse direction right) Specify next point or [Undo]: <Ortho on> 10′ (mouse direction up)

Specify next point or [Undo]: 10′

(mouse direction left)

Specify next point or [Close/Undo]: 10′ Specify next point or [Close/Undo]: c (enter) for drawing “A”

Note: [Close/Undo], is called alternate option, if you want to close you have to choose C (which is capital in Close), if you want to Undo one time then press U (which is capital in Undo)

To draw angular line, you need to specify angle with <angle (like <45) then enter, and length of line then enter for complete line sagement.

Esc is use for cancel any command and finish line command.

RECTANGLE

Draw menu: RECTANGLE

Tools Bar Draw rectangle

Command entry: REC (enter)

Specify first corner point or [Chamfer/Elevation/Fillet/Thickness/Width]:

(click where your rectangle corner)

Specify other corner point : @X,Y [@12’,12]

Rectangle